Skip to main content
FREE Delivery!|(414) 485-9466
Gravel, Stone and Soil for Milwaukee County, WI

Gravel, Stone and Soil for Milwaukee County, WI

What should you order for a driveway, a drainage run or a new lawn here? For gravel, stone and aggregate delivery in Milwaukee County, WI, Wisconsin Rock Supply keeps the answer simple: traffic bond for a base that packs hard, breaker run underneath it, and clean stone or sand for everything else. Milwaukee County sits on brown silty clay loam that drains slowly, so material choice matters more than volume.

Materials Delivered in Milwaukee County

Order by size, coarsest to finest. Start at the bottom of the hole and work up, and the list almost sorts itself.

Traffic bond carries most of the work in this county. It is the Wisconsin name for dense-graded base. Those designations help you match a set of plans to the material you order.

For paving, bedding goes down as Mason Sand or Washed Sand, both of which level and pack under brick, block and slabs. Around the house, RipRap armors slopes and culvert outlets against wave action and spring runoff.

Ground Conditions Across Milwaukee County

Start from the working season and time your delivery around it. Clay sites stay soft after the thaw and after heavy rain, so base and paver work goes best once the ground has drained, from late spring into fall.

Frost drives the base depth here. Cold winters and a spring thaw that works down from the surface mean wet clay over still-frozen ground cannot drain, so it turns soft and a thin gravel base heaves and ruts. Frost depth runs at least 48 inches for footings under the Uniform Dwelling Code, and 48 to 72 inches under pavement by late winter. Wet ground also means water ponds on flat lots and runs off to ditches, which is where drain rock and clean stone earn their place.

Along the Lake Michigan shore, waves, high lake levels, groundwater seepage and freeze-thaw wear back clay and till bluffs. Inland, runoff off slow-draining clay scours ditches and stream banks. Rip rap handles both.

Delivery Across Milwaukee County

Order online and Wisconsin Rock Supply brings bulk material to your site, from Milwaukee and Franklin to Oak Creek, South Milwaukee, Cudahy, Greendale, St. Francis and Hales Corners. You size a load by the ton or by the cubic yard, depending on how you measure the hole you are filling.

Bulk delivery means a truck tips the material where you want it, so think about access before the load arrives. Leave room for the truck to reach the pad without crossing a soft lawn, and pick a day when the ground has drained. Spreading goes faster when the pile sits close to the work.

Choosing the Right Material

Ground next door is not always the same ground. Ozaukee County and Racine County share the clay-rich glacial till and old lake-bed clays and silts that drain slowly, so the base and drainage choice looks much like Milwaukee County. Racine County spans more than one zone, running into the glacial plains and Kettle Moraine ground as well.

Waukesha County sits on lime-rich glacial till under a cap of silt loam loess, with sand and gravel in outwash plains and peat and muck in marshes and kettle bottoms. That outwash ground drains faster, so a driveway there can sometimes carry a thinner base, while the muck pockets need the same correction breaker run gives here. On this county's tight clay, base depth and drainage matter more than the surface stone you pick.

Order Gravel, Stone and Soil in Milwaukee County

Wisconsin Rock Supply delivers bulk gravel, stone, sand, topsoil and mulch across Milwaukee County, from Milwaukee and Franklin to Oak Creek, Cudahy, Greendale, St. Francis and Hales Corners. Pick your material, size the load and place the order online. When the truck arrives, the pile lands where you need it and the work can start.

Towns we deliver to in Milwaukee County

Frequently Asked Questions

Common questions about gravel and aggregate delivery in Milwaukee County

What is traffic bond and what is it used for in Milwaukee County?

Traffic bond is the Wisconsin name for dense-graded base, a crushed mix of stone and fines that compacts into a hard, tight surface. Buyers order it for driveways, parking pads, shed floors and patio bases, and it usually sits on a breaker run sub-base where the ground is soft or clay-rich.

How deep should a gravel driveway base be in Milwaukee County?

Base depth depends on the ground under it, not a flat rule. Frost reaches at least 48 inches for footings under the Uniform Dwelling Code and 48 to 72 inches under pavement by late winter, and wet clay over frozen ground cannot drain. Build in enough compacted traffic bond to bridge that soft spring layer, and add breaker run first where the subgrade is weak.

How much gravel do I need for my project?

Measure the area in square feet, then multiply by the depth you want in feet to get cubic feet. Divide by 27 for cubic yards, or order by the ton once you know the material. Deliveries are sized either way, so a rough sketch of the pad or trench with its depth is enough to start.