Can I order material for a commercial or contractor job?

Yes. You can order the same bulk materials for a commercial or contractor job as for a home project. Traffic bond, breaker run, crushed stone and sand all go out by the ton or the yard, sized to the job. Order online with your quantities and delivery point, and we will route the load to your site.

When is the best time of year to order base material in St. Croix County?

Late spring through fall is the practical window. Wait until frost is out and soils have drained. Ordering early in the season helps you get material when your site is ready.

What is the difference between topsoil and fill dirt?

Fill dirt is for structure, topsoil is for growing. Fill dirt raises grade, fills low spots and backfills before topsoil goes on. Pulverized topsoil, which many buyers call black dirt, is screened fine and spread as the top layer for lawns, grading and bed prep. Use fill first, then cap it with topsoil.

Gravel, Soil and Stone for St. Croix County, WI

Planning a driveway, a patio base or a drainage run, you need gravel, stone and aggregate delivery in St. Croix County, WI. Wisconsin Rock Supply sells bulk material by the ton and drops it where you are working. Most jobs here start with traffic bond, the crushed dense-graded base that packs hard under a drive or a shed pad.

This county sits on glacial till and outwash. Some ground is sand and gravel, some is silty loam capped with windblown silt, and the low, wet spots are peat and muck. That mix decides how deep your base goes.

Materials Delivered in St. Croix County

Traffic bond is the workhorse. It is the crushed dense-graded base Wisconsin suppliers sell under that name. Order it for driveways, parking pads and the base under patios and sheds. For those jobs, choose 3/4" Traffic Bond.

Breaker run is the coarse layer underneath. It is stone run through a primary crusher to 6 inches or less, specified as Section 311, and it goes in over soft or clay ground and at construction entrances. Cap it with traffic bond. See Breaker Run.

Round it out with Natural Pea Gravel for walkways and play areas, or Fill Dirt for raising grade before topsoil goes on. Both suit the work this county sees.

Ground Conditions Across St. Croix County

The failure mode here is a thin base over wet ground. Spring thaw hits silty and loamy spots first, and they heave and soften while the subsoil is still frozen. Water cannot drain down, so it sits in low spots, wetlands and flat fields. Standing water like that softens the ground, so the answer is a firmer base and a way to drain it, not a thicker surface layer.

Frost goes deeper and leaves the ground later than in southern Wisconsin. Footings sit at a minimum depth of 48 inches under the Uniform Dwelling Code. For drives, dig out the soft material, put breaker run down, compact, then build traffic bond on top.

Sandy outwash drains fast and takes a thinner base. Dense till is the opposite. It slows water from soaking in, so plan a drainage layer of clear stone or drain rock and get the grade moving away from the building.

Snowmelt and rain carry loose sand and silt off bare slopes and cleared lots into ditches, streams and lakes. Protect stream and lake banks with rip rap before the ground is bare again.

Delivery Across St. Croix County

Order online and choose tons or yards. A ton is weight, a yard is volume, and the conversion depends on the material. Traffic bond runs heavier per yard than topsoil, so the same yard count is not the same tonnage. If you know the area and depth you need, the calculator sizes the load for you.

Bulk delivery means a dump truck that needs room to back in and a clear spot to tip. Mark where you want the pile so the driver can place it close to the work and save you a wheelbarrow day.

We deliver to Hudson, New Richmond, Baldwin, Somerset, Hammond, Roberts, Woodville, Glenwood City, Star Prairie, Wilson, Deer Park and Houlton, along with the surrounding towns.

Spring is the tight window. Plan base work for after the frost is out and the soils have drained.

Choosing the Right Material

Ground changes as you cross the line, and so does the right base. Pierce County sits in the Driftless Area and western coulees, where silt loam formed in windblown loess over sandstone and dolomite. Slopes are thin and stony, with sandy and silty river deposits on valley floors. That means more slope armoring and rip rap work, and more care with drainage on ridge tops than you need on St. Croix outwash.

Dunn and Barron counties share this county's ground zone, so the material picture is similar. Expect the same till and outwash mix, the same peat and muck in bogs, and compare typical projects instead: driveways, shed pads and drainage runs sized to the same base depths.

Pick by job, not by habit. New drive over firm ground takes traffic bond. Soft or clay ground takes breaker run first, then traffic bond. Bedding and walkways take screenings. Drainage takes clear stone or drain rock. Lawns take pulverized topsoil, and raised beds take garden mix.

Size Your Load and Place the Order

Run your numbers through the calculator before you order. Enter the area and the depth, and it converts to tons or yards so the load fits the job. Base material is the one part of the project worth getting right the first time. Pick your materials and delivery point, and order your traffic bond, stone and topsoil for St. Croix County today.

Order Traffic Bond and Crushed Stone in St. Croix County, WI