Bulk Gravel Delivery to Galesville, WI

Wisconsin Rock Supply handles gravel and aggregate delivery in Galesville, WI, from traffic bond and breaker run to sand, topsoil and decorative stone. This part of Trempealeau County sits on silt loam over sandstone and dolomite, so what you put under a patio matters as much as what you lay on top. Order by the ton or the yard and we deliver.

Materials for Galesville Projects

Most patio and flatwork jobs here start with what goes under the pavers. Get the bedding layer wrong and the slabs rock, settle and hold water within a season.

For paver and flagstone bedding, order Screenings, sold locally as stone screenings or stone dust. Screened fines compact to a hard, flat plane, which is exactly what a paver bed needs at about an inch. For a walkway or a garden path, Walkway Gravel gives you a finer, more walkable surface.

Below that bedding sits the structural layer. 3/4" Traffic Bond is the Wisconsin standard, a crushed dense-graded base that packs hard and carries the load. Where ground is soft or clay-heavy, start with Breaker Run and cap it with traffic bond.

Around the edges of a patio, drainage decides how long the base lasts. Drain Rock handles French drains, downspout runs and drainage behind a retaining wall. RipRap armors a slope or culvert outlet against spring runoff.

Ground and Conditions in Galesville

The failure mode you see most on hillside patios here is a base that was too thin. Silty loam holds water, and when frost comes out in early spring the soil softens and the base ruts or shifts. A two-inch base on a slope will not survive that.

A path on this silty ground needs a deeper base and a way to shed water. Excavate deeper than you think you need, build a thicker traffic bond base, compact it in lifts, then bed the pavers on screenings. On a slope or near a hillside seep, add a drain rock layer so water has somewhere to go.

Timing matters too. Base work runs from the end of the spring thaw into late fall. Wet silty soil on a steep grade ruts easily, and low valley sites should allow for high water after big storms. Frost reaches 48 to 72 inches under pavement by late winter, so shallow base work is a gamble.

Delivery to Galesville and the Surrounding Area

Order online and choose tons or cubic yards. Tons are exact weight, which suits stone and base. Yards are easier for sand, topsoil and mulch. To estimate, multiply length by width by depth in feet, divide by 27 for yards, then check the product page for the conversion to tons.

We deliver bulk to Galesville and across Trempealeau County, including Arcadia, Trempealeau, Osseo, Whitehall and Independence. Tell us where the truck can set down and how far the pile needs to be from the work.

Questions from Galesville Buyers

What gravel is best for a driveway in Galesville?

Start with 3/4" Traffic Bond. It is the dense-graded base sold across Wisconsin as traffic bond, and it compacts hard enough to carry a truck. On soft or clay ground, put Breaker Run underneath first. Finish with Driveway Gravel if you want a looser wearing surface on top.

How much material will my project need?

Measure the area and decide your depth first. A patio base goes down thicker than a paver bedding layer, so decide both depths before you calculate. Multiply length by width by depth in feet and divide by 27 for cubic yards, then use the product page to convert to tons.

Size Your Patio Base Before You Order

Use the calculator on each product page to turn your measurements into tons or yards, and check the depth guidance for bedding versus base. When your numbers are ready, order traffic bond, screenings and drain rock from Wisconsin Rock Supply for delivery in Galesville.