Skip to main content
FREE Delivery!|(414) 485-9466

Marinette County, Wisconsin ยท Free Delivery

Bulk Gravel Delivery to Pembine, WI

Free delivery to Pembine on every order, with loads arriving in as fast as 2 business days.

Delivering to Pembine, WI

Free delivery on every order.

  • Free delivery to Pembine
  • Order from 1 ton
  • As fast as 2 business days

Gravel delivered to Pembine

Crushed gravel and base materials that compact under tires.

Rock & Stone delivered to Pembine

Graded crushed stone for drainage, concrete and heavy work.

RipRap

4" to 12"+ rock for shorelines, slopes and culvert outlets

From 1 Ton Delivered, FREE to your Doorstep

Cost per ton lowers the more you order!

Free delivery to Pembine

Decorative delivered to Pembine

Rounded stone for beds, borders and water features.

Sand delivered to Pembine

Washed sand for masonry, concrete and leveling.

Soil, Fill & Mulch delivered to Pembine

Soil and fill by the ton, mulch by the cubic yard.

How delivery to Pembine works

  1. 1

    Pick the material and quantity.Open a product to see your price, with free delivery to Pembine.

  2. 2

    Choose a delivery date at checkout.As fast as 2 business days for most Pembine addresses.

  3. 3

    Clear a drop spot.The truck tips the load where you mark it. Note low wires or branches when you order.

Not sure how much you need?

Enter length, width and depth and the calculator returns the cubic yards and tons for your project.

Open the calculator

Wisconsin Rock Supply stocks gravel and aggregate delivery in Pembine, WI, and the counties around it. That starts with traffic bond, the crushed dense-graded base this part of Wisconsin runs on, and it keeps going through clear stone, screenings, sand, topsoil and rip rap. Local ground runs from sandy outwash to dense till, so the right material matters as much as the tonnage.

Materials for Pembine Projects

If you are setting pavers or pouring flatwork, the layer nobody sees decides how the job ages. Bedding has to pack hard and drain. The wrong material lets a patio rock, settle and heave after a thaw.

Start with Screenings, the material Wisconsin suppliers sell as stone dust or quarter inch screenings. Screened fine and angular, it compacts into a flat, firm bed for pavers, patio slabs and walkway joints, and it also works as a hard top dressing on a drive.

Under that bedding, the base carries the load. 3/4" Traffic Bond is the crushed dense-graded base this market orders by name. It locks up hard under a plate compactor with almost no movement. Some yards label it road gravel; ask for traffic bond and you get the graded product, not a pit run blend.

Where the ground is soft or clay-heavy, cap a lift of Breaker Run with traffic bond. The coarse stone and fines in breaker run bridge over wet spots that would swallow a thin base.

For drainage behind a retaining wall, along a footing or in a French drain, order Drain Rock, the clear drain stone with the fines screened out so water moves instead of pooling.

Two more worth knowing for flatwork: Washed Sand for leveling and bedding under slabs, and Mason Sand for brick and block work, paver joints and play areas.

Ground and Conditions in Pembine

The failure you see here is a base that was too thin. Wet, silty or loamy spots heave and soften as the ground thaws, and a patio or drive built on a shallow lift cracks and dips within a season or two.

Frost drives that. This region carries frost at least 48 inches deep for footings under the Uniform Dwelling Code, and it goes deeper and leaves later than it does in southern Wisconsin. On this ground, dig out the soft soil, put breaker run over wet spots, build the traffic bond base in compacted lifts, and give water somewhere to go.

Drainage is the other half. Sandy outwash sheds water quickly, but dense till does not, so snowmelt and heavy rain sit in low spots and flat fields until the subsoil thaws. A drain rock layer or a clear stone blanket at the low corner keeps a patio edge from turning into a mud pocket.

Timing matters too. Ground work waits until frost is out and soils have drained.

Delivery to Pembine and the Surrounding Area

Ordering online is straightforward once you pick a unit. Bulk material is sold by the ton or by the cubic yard, and the two are not the same number: a yard of traffic bond weighs more than a yard of topsoil or mulch.

Estimate your quantity before you order. Measure the length, width and depth, then use the calculator to turn them into tons or yards for that material. Ordering a yard or two short means a second delivery and a cold joint in the base.

Wisconsin Rock Supply delivers bulk loads to Pembine and the rest of Marinette County, including Marinette, Peshtigo, Porterfield, Niagara and Crivitz. Place the order, tell us where the truck can reach on your site, and we will build the load to your project.

Order Your Base Material for Pembine

Get your square footage and depth into the calculator, pick your materials, and place the order online. Traffic bond, screenings, drain rock and sand ship by the ton or yard to Pembine and across Marinette County. Put your project dimensions in and we will load the right material for the base under your pavers and flatwork.

Frequently Asked Questions

Common questions about gravel and aggregate delivery in Pembine, WI

What gravel is best for a driveway in Pembine?

Traffic bond is the standard answer here. As a 3/4 inch dense graded base it compacts hard, sheds water and carries vehicle weight, and it is the material specifiers call dense graded base. On soft or clay ground, lay breaker run first and cap it with traffic bond. Top the finished drive with driveway gravel if you want a finer running surface.

How much material will my project need?

Measure the area, then multiply length by width by depth in feet to get cubic feet, divide by 27 for cubic yards, and convert to tons using the material's weight. Base depths run deeper than most people expect, since a thin lift is what fails. Use the site calculator with your dimensions to get the tonnage.

How is the material measured?

You can order by the ton or by the cubic yard, whichever suits how you plan the job. If you tell us the area you are covering and the depth you want, we will work the quantity out with you rather than leaving you to guess.