Mason Sand for Patios in Reeseville, WI

If you are bedding pavers or pouring flatwork, gravel and aggregate delivery in Reeseville, WI starts with what goes under the slab. Wisconsin Rock Supply sells traffic bond, mason sand and the stone that keeps a patio flat through the spring thaw. Reeseville sits in Dodge County, where silt loam over lime-rich glacial till holds water longer than most crews expect.

Order the base and the bedding together so the layers match and the patio drains the way it should.

Materials for Reeseville Projects

A patio is only as good as the bed under it. That means traffic bond for the base, a clean bedding layer, and the right stone around the edges. Here is what most jobs in Reeseville take.

3/4" Traffic Bond is the local name for dense graded base. It packs hard under pavers, patios, shed pads and driveways. Some yards label it road gravel, but ask for traffic bond and you get the same crushed dense-graded product.

Mason Sand is the bedding layer. Screed it an inch thick over compacted base, set the pavers, and sweep more into the joints. It also works for block work and play areas.

Screenings are the other bedding choice. Stone dust locks tighter than sand, so it holds a paver edge on a slope and packs into a hard top dressing.

Breaker Run goes underneath when the ground is soft. It is coarse crushed stone with the fines still in it, and it bridges over clay and muck before traffic bond goes on top.

Around the edges, Drain Rock handles downspouts, French drains and the wet spots that show up along a foundation after snowmelt.

Ground and Conditions in Reeseville

The failure you see here is a thin base, not bad pavers. Silt loam sits over lime-rich glacial till in this part of Dodge County, and water collects in low ground between the drumlins and moraines. Slow-draining till holds spring rain and snowmelt near the surface. A two-inch base on that ground will heave, tip and cup within a season or two.

Soft ground in Reeseville calls for a deeper base and a way for water to drain. Dig out until you hit firm ground, put down a separation layer, then compact traffic bond in lifts instead of one thick dump. A thicker compacted base suits a patio; go deeper still where the subgrade stays soft or a truck will park on it.

Frost drives the rest. Frost depth runs at least 48 inches for footings under the Uniform Dwelling Code and 48 to 72 inches under pavement by late winter. Frost leaves earlier here than up north, but silty and clayey spots still heave and soften during the thaw. Base, driveway and paver work runs from the end of the spring thaw into late fall, and frozen ground stops compaction in winter.

Erosion matters too. Runoff from rain and snowmelt washes silty soil off bare slopes and graded sites, and cuts into ditches. Seed or armor bare ground before fall, and use RipRap at culvert outlets and slope toes where the water comes out fast.

Delivery to Reeseville and the Surrounding Area

Buy base and bedding by the ton when you know the weight, and by the cubic yard when you are working from a volume. One yard of traffic bond runs heavier than a yard of sand, so the two do not convert the same way. Measure the area, set the compacted depth, and let the site calculator turn that into tons or yards.

Figure a little extra on bedding and joint sand, since screeding and sweeping always lose some. Order the whole job at once where you can, so the base, bedding and edge stone arrive together and the crew is not waiting on a second load.

Wisconsin Rock Supply delivers bulk material across Dodge County, including Beaver Dam, Watertown, Waupun, Mayville and Horicon. Place the order online and pick your delivery window.

Questions from Reeseville Contractors

What gravel is best for a driveway in Reeseville?

Traffic bond is the right base for a Reeseville driveway. It is the local name for 3/4 inch dense graded base, and it compacts into a hard, tight surface that sheds water. Cap it with driveway gravel if you want a finer top, or leave the traffic bond exposed on a working drive. Skip washed stone for this, since clear stone will not lock up.

How much material will my project need?

Multiply the square footage by the compacted depth in feet, then divide by 27 for cubic yards. The calculator converts that volume to tons for traffic bond, sand or any other material. Add about ten percent for compaction loss and spillage. Run your numbers through the site calculator and order by the ton or the yard, whichever you prefer.

Get Your Patio Base Sized Right

Run your patio or driveway measurements through the calculator and let it convert square footage into tons or yards. Then place the order for traffic bond, mason sand and the stone around it, and Wisconsin Rock Supply will deliver the load to your site in Reeseville. Start your order online when your numbers are ready.