Mason Sand for Patios in Arkansaw, WI

Wisconsin Rock Supply stocks gravel and aggregate delivery in Arkansaw, WI, from traffic bond to bedding sand. You order by the ton, and we deliver bulk to your site. This is silt loam country over sandstone and dolomite, so what goes under a patio matters as much as what sits on top.

If you are setting pavers or pouring flatwork, the base and bedding you choose decide whether the surface stays flat after a few winters.

Materials for Arkansaw Projects

Patio and flatwork work starts with bedding. For pavers, that means Screenings, the 1/4 inch stone dust Wisconsin suppliers sell for paver and patio bedding. It packs hard, spreads smooth and locks the pavers in place.

Under the bedding goes the structural base. 3/4" Traffic Bond is the dense graded base sold across Wisconsin as traffic bond, and it is the material that carries the load under a patio, driveway or shed pad.

For sand bedding and leveling, Washed Sand goes under slabs and works as a leveling course. Mason Sand handles brick and block work and paver joints, and doubles as play sand.

Where a patio meets a slope or a downspout, add drainage. Drain Rock is clear drain stone for French drains and foundation drains, and 3/4" Crushed Stone is clear stone for backfill and drainage beds.

Ground and Conditions in Arkansaw

The failure a thin base shows here is rutting and settlement. Silty loam on a slope or at a hillside seep holds water and softens as frost comes out, so a patio base that is too shallow moves before the pavers ever fail.

Frost drives the fix. Footings need at least 48 inches under the Uniform Dwelling Code, and pavement frost depth runs 48 to 72 inches by late winter. Excavate deep enough, compact the traffic bond in lifts, then bed the pavers on screenings.

Runoff on steep ridges washes loess downhill and cuts gullies, so plan drainage before you build. Base work runs from the end of the spring thaw into late fall, and wet silty soil on steep grades ruts easily. Low valley sites should allow for high water after big storms.

Delivery to Arkansaw and the Surrounding Area

Order online, then decide whether to buy by the ton or the cubic yard. Bulk aggregate is usually sold by weight, while sand and topsoil are often easier to figure in yards. Match the unit to how you measured the hole.

To estimate quantity, take length times width times depth in feet, then divide by 27 for cubic yards. For weight, multiply the yards by the density of the material. Screenings, traffic bond and sand all run heavier than topsoil, so check before you order.

We deliver bulk to Arkansaw and across Pepin County, including Durand and Stockholm. Spring weight limits on posted county, town and village roads can affect timing while frost comes out.

Questions from Arkansaw Buyers

What gravel is best for a driveway in Arkansaw?

Start with 3/4" Traffic Bond, the dense graded base sold across Wisconsin as traffic bond. It compacts hard and carries traffic. On soft or clay ground, put breaker run underneath as a heavy sub-base, then cap it with traffic bond. Top the finished drive with Driveway Gravel if you want a finer surface.

How much material will my project need?

Measure the area and the depth you need. Multiply length by width by depth in feet, then divide by 27 for cubic yards. Bedding sand for pavers usually goes down as a thin layer, while a compacted traffic bond base runs deeper. Use the calculator on the product page to convert your numbers into tons.

Get Your Patio Base Ordered

Figure your square footage and depth first, then run the numbers through the calculator to see the tons you need. Once you have your quantity, order the traffic bond, screenings and sand for your Arkansaw project online and we will deliver it to your site.