3/8 Inch Crushed Stone for Pathways in Bagley, WI

For gravel and aggregate delivery in Bagley, WI, Wisconsin Rock Supply stocks the materials local crews ask for by name. That starts with traffic bond, the dense graded base sold across Wisconsin, and runs through washed stone, screenings, sand and soil. In the Driftless Area, silt loam sits over shallow bedrock, so water moves fast and a path built without the right stone shows it.

Materials for Bagley Projects

Paths and walkways are where the small stone matters most. The surface you walk on and the base under it are two different orders, and mixing them up is the most common mistake on a Bagley path.

Path and walkway stone

Start with 3/8" Crushed Stone, also called 3/8 inch chips. It packs into a firm, walkable surface and works as a top layer over compacted base. For bedding under pavers and a hard-packing top dressing, use Screenings, which Wisconsin yards sell as stone dust. Walkway Gravel gives you a finer, finished surface for garden paths. For a looser, decorative path, Natural Pea Gravel drains well and stays easy underfoot.

The base under it

Every path needs structure below the surface stone. 3/4" Traffic Bond is the crushed dense-graded base that packs hard. Where ground is soft or clay-heavy, Breaker Run goes in first as a coarse sub-base, then traffic bond caps it.

Ground and Conditions in Bagley

A thin base is the failure you see first here. On a slope, or at a hillside seep, silty soil holds water and softens as frost comes out, and a path with only a thin layer of stone under it ruts and pumps within a season.

Piling on more surface stone will not help; a deeper base and drainage will. Excavate enough to fit a thicker compacted layer of traffic bond under the walking surface, and add a drainage layer where water collects. Frost reaches 48 inches or more under pavement by late winter, so a base that stays saturated through freeze-thaw will keep moving.

Runoff is the other factor. Rain and snowmelt come fast off the steep ridges into narrow valleys, and loess on ridge-top ground erodes easily. Paths on a grade need a crowned surface and a stone edge holding the fill. Base work runs from the end of the spring thaw into late fall, and wet silty soil on steep grades ruts under a loaded truck, so timing matters.

Delivery to Bagley and the Surrounding Area

Order online and choose your quantity by the ton or the cubic yard. Most path and base material is sold by weight, while soil, sand and mulch are often easier to figure by volume. Multiply length by width by depth in feet, divide by 27 for cubic yards, then check the product page for the conversion the yard uses.

Bulk delivery to a job in Bagley comes by dump truck and drops where the truck can safely reach. Have the area clear, mark anything overhead, and know where you want the pile. We also deliver to Platteville, Lancaster, Boscobel, Fennimore and Cuba City in Grant County.

Questions from Bagley Buyers

What should I have ready when the truck arrives?

Clear the drop area and make sure the driver can pull in and out without backing over a soft edge. Move vehicles, mark sprinkler heads and low wires, and decide in advance whether the pile goes in one spot or gets tailgated along the run. Wet silty ground on a slope is the spot most likely to rut, so put the pile on firm, level gravel if you can.

What is the best base under pavers in Bagley?

Use compacted traffic bond for the structural base, then a bedding layer of screenings to set the pavers. On soft or clay-heavy ground, put breaker run in first and cap it with traffic bond. The reason is local: silt loam holds water and softens as frost comes out, so the base has to carry the load and drain rather than sit saturated.

Figure Your Path Quantity

Measure the path, set the depth, and let the quantity calculator turn that into tons or yards before you order. Add a little for compaction, since base stone settles as it packs. When your numbers are ready, place the order and Wisconsin Rock Supply will bring the material to your Bagley site.