3/8 Inch Crushed Stone for Pathways in Mount Hope, WI

Spring weight limits and the thaw set the calendar for gravel and aggregate delivery in Mount Hope, WI. Base work here runs from the end of the thaw into late fall. On the steep ridges above the valley, silty loam softens as frost leaves, so a thin base ruts fast. Wisconsin Rock Supply delivers traffic bond and washed stone to sites across Grant County.

Materials for Mount Hope Projects

Paths and walkways need fines, not just clean stone. Fines let the surface lock together under a wheelbarrow and a boot. That is why the mixes below pack hard instead of shifting loose.

Screenings, also called stone dust, are the go-to bedding for pavers and flagstone. Spread a thin layer, screed it, and water it in. The same material works as a hard-packing top dressing on a drive or garden path.

3/8" Crushed Stone is the finer option. Use it for pipe bedding, fine drainage, and as a top coat over a compacted base. It sits well on walkways that see foot traffic and light carts.

Walkway Gravel is the quickest path surface to place. It spreads evenly, rakes out, and takes a garden hose without turning to mud.

Every path needs a base under the fines. 3/4" Traffic Bond is the dense-graded material Wisconsin suppliers sell for driveways, parking pads, and shed or patio bases. It packs hard and holds an edge.

Where the path crosses soft or clay ground, start with Breaker Run. It is coarse crushed stone with the fines left in, and it bridges soft spots before traffic bond goes on top.

Ground and Conditions in Mount Hope

Silt loam formed in windblown loess sits over sandstone and dolomite here. On steep slopes and some ridge tops it runs thin and stony. On valley floors and terraces you hit sandy and silty river deposits instead.

Around Mount Hope, trouble usually starts with a thin base on a slope or at a hillside seep. It ruts, pumps, and loses its edge in one wet spring. A thicker top coat will not stop it; build the base deeper and give water a way out.

Rain and snowmelt run fast off the ridges into narrow valleys. Heavy storms can flood valley towns, and where bedrock is shallow, water also drains through cracks, sinkholes, and springs. Plan a drainage layer under any path that crosses a wet spot.

Frost depth reaches at least 48 inches for footings under the Uniform Dwelling Code, and 48 to 72 inches under pavement by late winter. Silty soil holds water and softens as frost comes out. Compact traffic bond in lifts, and keep the grade above the surrounding ground.

Delivery to Mount Hope and the Surrounding Area

Ordering online starts with a quantity. Decide whether you want tons or cubic yards, then check the calculator on each product page. Stone is usually sold by the ton, and soil and sand by the yard.

To estimate, measure the length and width of the path, then multiply by the depth you want in feet. A compacted base over even a small path area adds up quickly. Round up, since compaction pulls the number down.

We deliver bulk loads to Mount Hope and to Platteville, Lancaster, Boscobel, Fennimore, and Cuba City in Grant County. Tell us where the truck can back in and whether the ground is firm enough to take the weight.

Figure Your Path Quantity, Then Place the Order

Run your path measurements through the quantity calculator on each product page before you order. It converts your square footage and depth into tons or yards, so you buy what the job needs. When your numbers are ready, place the order online and Wisconsin Rock Supply will schedule the delivery to your Mount Hope site.